Worth Data 5000 TriCoder s El manual del propietario descargar pdf (Pagina 43)

The terminal will do an Access Point Scan and report on the three Access Points with the strongest signals

contacted, (or fewer than three is less contacted). You can update the display by pressing ENTER to rescan.

The display will have the following format:

WorthData1 WPAv1

WorthData2 WEP

WORTHDATA5 WEP

ENTER:Rescan or F1: Exit

If no Access Point can be located, nothing will be displayed except the bottom line.

The left column is the SSID of the detected access point and the right column is the security method enabled

on that access point.

Remember when doing a site test in a warehouse, as the contents of the warehouse change the interference

changes too. So if you have a marginal signal on the Site Survey, it may turn into poor performance later.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 135 136

Sin comentarios

Worth Data 5000 TriCoder s El manual del propietario Pagina 43